Remove the NT8D81BA cable 449
Tools list
Ty-wrapcutter
Ty-wraps
Needle-nose pliers
Slotted screwdriver
Remove the NT8D81BA cable
Follow the steps in Procedure 74 "Removing the NT8D81BA cable" (page
449) to remove the NT8D81BA cable.
Procedure 74
Removing the NT8D81BA cable
Step Action
1Identify the I/O panel and backplane designation that corresponds
to the LEFT slot of the pair of card slots, viewed from the front, in
which the Media Card 32-port or ITG-Pentium 24-port trunk card
was installed.
2Disconnect the filter from the I/O panel using a screwdriver and
needle-nose pliers. Retain fasteners.
3Power down the IPE shelf.
4Remove the IPE module I/O safety panel.
5Toremove the ribbon cables from the IPE backplane:
a. Applygentle pressure on the tab on the right side of the shroud
while pulling on the connector until it pulls free from shroud.
b. Removeconnector 1 first, then remove connectors 2 and 3.
6Discard the NT8D81BA cable.
—End—

Install NTCW84JA filter and NT8D81AA cable

Follow the steps in Procedure 75 "Installing the NTCW84JA filter and
NT8D81AA cable" (page 450) to install the NTCW84JA filter and NT8D81AA
cable.
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21December 2007
Copyright© 2007, Nor tel Networks
.