Nortel Networks NN43001-563 Create the IP Trunk 3.01 (and later) node dialing plan using TM 3.1

Control node access with SNMP community name strings 253

Create the IP Trunk 3.01 (and later) node dialing plan using TM 3.1

Follow the steps in Procedure 24 "Conﬁgure the ITG Dialing Plan General

tab" (page 253) to conﬁgure the IP Trunk 3.01 (and later) node dialing plan

in TM 3.1. Use this procedure to create the dialing plan for the ﬁrst node in

the network. This procedure also can be used to create a dialing plan for a

new node in a very small network. If adding a new node to a large existing

network, it is more efﬁcient to retrieve the IP Trunk 3.01 (and later) node

dialing plan from an existing node.

A dialing plan consists of a number of IP Trunk 3.01 (and later) destination

nodes and one or more dialing plan entries for each destination node. Select

a destination node, deﬁne the destination node protocol capability, decide if

QoS monitoring is to be enabled for this destination node, and enter one

or more ESN dialing plan entries for each destination node. Repeat this

procedure for all destination nodes in the IP Trunk3.01 (and later) network.

The dialing plan information entered in TM 3.1 must match the ESN data

entered in the LD 15, LD 16, LD 86, LD 87 and LD 90. Keep the dialing plan

entries consistent between the Meridian 1/CS 1000M and the IP Trunk3.01

(and later) node. Transmit the dialing planfrom TM 3.1 to the IP Trunk3.01

(and later) node during installation, card replacement, when IP Trunk 3.01

(and later) nodes are added to the network, or whenever the dialing plan

on TM 3.1 IP Trunk3.01 (and later) is changed.

Each IP Trunk3.01 (and later) trunk node shares one dialing plan for all

cards in the node. The IP Trunk 3.01 (and later) node dialing plan translates

the dialed digits in the system ISDN Signaling Call Setup message,

according to ESN translation type, into the Node IP addresses of the IP

Trunk3.01 (and later) destination nodes.

Procedure 24

Conﬁgure the ITG Dialing Plan General tab

Step Action

1In the IP TelephonyGateway – ISDN IP Trunk window, select the

new IP Trunk3.01 (and later) node for which a dialing plan is to be

built. Select menu Conﬁguration > Node > Dialing Plan. The ITG

Dialing Plan window opens.

2In the ITG Dialing Plan window, select the menu Conﬁguration

> Add Remote Node. The ITG Dialing Plan – Remote Node

Properties window opens and displays the General tab. See Figure

59 "ITG Dialing Plan Remote Node Properties window General tab"

(page 254). The default Node drop-down list reads "Not deﬁned on

this TM 3.1 PC" and the Node IP address ﬁeld is blank. Click the

drop-down list to see a list of all the other IP Trunk3.01 (and later)

nodes conﬁgured on this TM 3.1 PC. The IP Trunk3.01 (and later)

node for which the dialing plan is being created is not seen.

Nortel Communication Server 1000

IP TrunkFundamentals

NN43001-563 02.01 Standard

Release 5.5 21December 2007