System commands LD 32 385
The card reset button is only availablein the TM 3.1 IP Trunk 3.01 (and
later) application when the IP trunk card is disabled.
Disabling the IP trunk card in LD 32 does not disable the Active Leader
or Backup Leader functions.
•"Disable the indicated IP trunk card when idle" (page 363).
This temporarily preventsthe IP Trunk3.01 (and later) node from seizing
the port from incoming calls.
•"Disable an indicated IP trunk card port" (page 364).
•"Enable an indicated IP trunk card" (page 364).
•"Enable an indicated IP trunk card port" (page 364).
•"Display IP trunk card ID information" (page 364).
This command displays the PEC (Product Engineering Code) for the card.
The PEC is as follows:
ITG 8-port trunk card – NT0961AA
ITG-Pentium 24-port trunk card – NT0966AA
Media Card 32-port trunk card – NT0966BA
The IP trunk card ID information displays the same IP trunk card serial
number that is displayed from the ITG shell using
serialNumShow.
•"Display IP trunk card status" (page 364).
•"Display IP trunk card port status" (page 364).
Table54 "LD 32 IP Trunk 3.01 (and later) maintenance commands" (page
385) shows a summary of the system administration commands available
in LD 32.
Table 5 4
LD 32 IP Trunk3.01 (and later) maintenance commands
Command Function
DISC l s c Disable the indicated card, where:
l = loop, s = shelf, c = card
DISI l s c Disable the indicated card when idle, where:
l = loop, s = shelf, c = card
Use the DISI command to disable the IP trunk
card instead of the DISC command. The
disablement of the IP trunk card is indicated by
the NPR011 message.
DISU l s c u Disable the indicated unit, where:
l = loop, s = shelf, c = card, u = unit
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21December 2007
Copyright© 2007, Nor tel Networks
.