Media Card 32-port trunk card (NTVQ01BB) 53
The onboard FPGAs are changed to the advanced family of device
architecture.
A new Compact Flash Drive is used for onboard C: Drive.
The faceplate has been re-designed for better ergonomics.
New firmware is developed to implement the above design
enhancements.
Table7 "Media Card 32-port tr unk card comparison" (page 53) provides a
comparison of the design features for the two versionsof the Media Card
32-port trunk card.
Tabl e 7
Media Card 32-port trunk card comparison
NTVQ01BA NTVQ01BB
MC Firmware Release 6.7 Release 8.0
Onboard DSP 14
DSP Module 1Nil
Compact Flash Drive Compact Flash Drive with lock
Pin Retention Compact Flash Drive with
Retaining Clip
Assembly description
The Media Card 32-port trunk card assembly comes with a pre-installed
SDRAM Module. The IP Trunk Application is installed on the C:/ drive.
Faceplate indicators and interfaces
The Media Card 32-port trunk card has a single slot faceplate. It uses
shortened lock latches to lock it in place. Refer to Figure 10 "Media Card
32-port trunk card" (page 52) on Figure 10 "Media Card 32-port trunk card"
(page 52).
Status LED
A single red LED indicates the enabled/disabled status of the card and
the status of the power-on self-test.
Where a DCHIP PC Card is installed in the Media Card 32-port trunk card
A:/ drive, the LED does not indicate the status of the DCHIP PC Card or
the DCHIP.
Reset button
The reset button enables the operator to manually reset the card without
cycling power to it. Use the reset button to reboot the card after a software
upgrade, or to clear a fault condition.
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.