TransmitIP trunk card configuration data from TM 3.1 to the IP trunk cards 265
Disable IP trunk cards whenever transmitting card properties or new
software.
Use the TM 3.1 Maintenance Windows, the TM 3.1 System Passthru
terminal, or a system management terminal directly connected to a TTY
port. Use the LD 32 DISI command to disable the IP trunk cards when idle.
In the TM 3.1 IP TelephonyGateway – ISDN IP Trunk window,select View >
Refresh and verify that the card status is showing "Disabled". If the card
status is showing "unequipped", configure the card in LD 14.
Totransmit the node properties, card proper ties,and dialing plan to Leader
0, follow the steps in Procedure 29 "Transmittingthe node properties, card
properties and dialing plan to Leader 0" (page 265).
Procedure 29
Transmittingthe node properties, card properties and dialing plan toLeader 0
Step Action
1From the TM 3.1 Navigator window,double-click the ITG ISDN IP
Trunksicon from the Services folder. The IP TelephonyGateway -
ISDN IP Trunk window opens.
2Select the IP Trunk3.01 (and later) node for which the properties are
to be transmitted from the list in the upper part of the window.
3Select Leader 0 from the list in the lower part of the window.
4In the IP TelephonyGateway - ISDN IP Trunk window, select menu
Configuration > Synchronize > Transmit.
5Leave the radio button default setting of Transmitto selected
nodes. Check the Node Properties, Card Properties and Dialing
Plan check boxes.
6Click the Start Transmit button.
Monitor progress in the TransmitControl window. Confirm that the
Node Properties, Card Properties and Dialing Plan are transmitted
successfully to the Leader 0 IP trunk card TN. At this point, it is
normal for transmission to Leader 1 and Followercards to fail.
7When the transmission is complete, click the Close button.
8Reboot the Leader 0 IP trunk card.
—End—
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21December 2007
Copyright© 2007, Nor tel Networks
.