254 Install and configure IP Trunk3.01 (and later) node
Figure 59
ITG Dialing Plan Remote Node Properties window General tab
3Select the destination Node to be added from the list. TM 3.1
provides the IP Trunk 3.01 (and later) Node IP address in a
greyed-out boxand fills in the node name in the Node Name field.
4Define Node capability for the destination node.
The default setting is SL1, which supports MCDN features. The
Node capability field defines the D-channel protocol used by the
destination IP Trunk3.01 (and later) node. The protocol must match
the protocol configured in LD 16 in the Route Data Block at the IFC
prompt with respect to SL1 vs. ESGF or ISGF QSIG interface (IFC),
and in LD 17 at the IFC prompt under ADAN DCH. In LD 16, if SIGO
is set to STD, then select the SL1 node capability. If SIGO is set to
ESN5, then select SL1ESN5 node capability. In a mixed ESN5 and
non-ESN5 network, configure an ESN5 prefix for the non-ESN5 IP
telephony gateways byusing the "esn5PrefixSet" command from
the ITG shell CLI. "Change default ESN5 prefix for non-ESN5 IP
telephony gateways" (page 271)
The choices are SL1, SL1 ESN5, ESIG, and ISIG for networks
consisting of Large Systems. For networks that include Small
Systems, the choices are H.323 V2, ISGF,ESGF, SL1, and SLI
ESN5.
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.