240 Install and configure IP Trunk3.01 (and later) node
a. Enter the ELAN node IP address in the Management LAN
Node IP field.
b. Enter the ELAN network interface gateway IP address in the
Management LAN gateway IP address field. The ELAN
network interface gateway (router) also functions as the voice
gateway (router).
c. Enter the ELAN subnet mask in the Management LAN subnet
mask field.
The Management LAN Node IP and Management gateway
IP addresses on the General tab and the Management IP
for Leader 0, Leader 1 and all Follower cards on the card
Configuration tab must be on the same subnet.
Do not click OK or Apply until the Configuration tab has been
completed.
—End—
Configure card properties
Procedure 19 "Configuring the IP trunk card" (page 240) explains how
to configure the IP trunk card roles, IP addresses, TN, card density and
D-Channel settings.
Each IP Trunk3.01 (and later) node requires a Leader 0 card and one
DCHIP card (which can be Leader 0) and can have a Leader 1 card, one or
more Follower cards,and additional DCHIP cards (which can be Leader 1
or Follower cards). Either Leader 0 or Leader 1 can have the Active Leader
status. On system power-up, Leader 0 normally functions as the Active
Leader and Leader 1 as the Backup Leader.
At other times, the Leader card functions can reversewith Leader 1 working
as the Active Leader and Leader 0 working as the Backup Leader.
Procedure 19
Configuring the IP trunk card
Step Action
1Click the Configuration tab. See Figure 52 "Configuration tab"
(page 241). If the single subnet option in the General tab was
selected earlier, the VoiceIP and Voice LAN gateway IP fields are
greyed-out.
2Select the Card role from the drop-down list.
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.