Nortel Networks NN43001-563 - page 335

Define the dialing plan information 335
In the TM 3.1 Navigator window, the Gatekeeperzone can be found by
left-clicking on the CS 1000M system, selecting Properties, and clicking on
the Network tab. See Figure 130 "Making a Gatekeeper zone" (page 335).
When provisioning the applicable devices in TM 3.1, use network zones
to coordinate the Gatekeeper information. The Gatekeeper zones were
defined on the CS 1000M. For information on configuring zones on the CS
1000M systems, see IP Peer Networking Installation and Commissioning
(NN43001-313).
Figure 130
Making a Gatekeeper zone
All nodes within a network are configured with the IP addresses of the
Primary and Alternate Gatekeepers in that network zone.
Follow the steps in Procedure 49 "Provisioning the IP Trunk3.01 (and later)
node to register with the Gatekeeper" (page 335) to configure the correct
network zone when provisioning an IP Trunk3.01 (and later) node.
Procedure 49
Provisioningthe IP Trunk 3.01 (and later) node to register with the Gatekeeper
Step Action
1Configure The IP Trunk 3.01 (and later) node to register with the
IP Peer H.323 GatewayGatekeeper. This can be done in either
of two ways, as follows:
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.