IP trunk card self-tests 407
Tabl e 65
Operational Measurement command
Command Description
resetOM This command returns all Operational Measurement parameters
collected since last log dump, including:
outgoing calls tried
outgoing calls completed
incoming calls tried
total voice time
total fax time
outgoing packets discarded
incoming packets out–of–sequence
average packet delay
average packet loss
number of Fallback-to-PSTN calls
Tabl e 66
DCHIP-only commands
Command Description
DCHenable Enable the DCH application on the card.
DCHdisable Disable the DCH application on the card.
DCHestablish Establish the DCH link when it is in release mode.
DCHrelease Release the DCH link when it is in establish mode.
DCHstatus Display the DCH application state.
DCHmenu This command allows the user to access the UIPC Debug Menu.
Once in passthru mode, the user has to "exit" the Debug Menu,
before issuing any other ITG Shell Commands.
dchipResTableShow Available from ITG shell. Show the Followers associated with
a DCHIP.
IP trunk card self-tests

During power-up, the IP trunk card performs diagnostic tests to check

correct operation. Use the faceplate RS-232 port on the IP trunk card to

monitor these tests. IP Trunk 3.01 (and later) sends messages indicating

the completion of each phase of testing and any detected faults, to this port.

Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21December 2007
Copyright© 2007, Nor tel Networks
.