280 Install and configure IP Trunk3.01 (and later) node
TM 3.1 Alarm Notification must be restarted whenever Control Files
are changed.
9If TM 3.1 Alarm Notification is running (a red traffic light is showing
on the tool bar), stop it by clicking on the red traffic light on the tool
bar. Restart it by clicking on the green traffic light.
10 If TM 3.1 Alarm Notification is not running (a green traffic light is
showing on the tool bar), start it by clicking on the green traffic light
to change it to red.
11 Enter the trap_gen command from the ITG shell. A series of
SNMP traps is emitted by the IP trunk card and appears in the TM
3.1 Alarm Notification browser window. Verify the device name
identifies the correct IP trunk card.
—End—
Make test calls to the remote nodes (ITG Trunk or IP Trunk)
Make test calls to ensure the following:
The IP Trunk3.01 (and later) system can process calls from each node
to a remote node.
The IP trunk cards are enabled.
QoS, as defined within the Dialing Plan window, is acceptable.
Check the IP Trunk3.01 (and later) operational repor t. If fallback to PSTN
occurs, examine the IP data network for problems. Also, check the IP trunk
cards’ dialing plan table and verify that the remote ITG Trunk2.x or IP Trunk
3.01 (and later) node is powered up, configured, and enabled.
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.