84 System description
— release
— establish
Retrieval of DSP information, such as:
DSP firmware
DSP self-test status
card reset
SNMP configuration (that is, community names and trap subscription)
alarm generation through SNMP traps
File transfer,including configuration files, software upgrade, dialing plan
files, bootp files, activity log, and call trace files
Codec profiles
Codec refers to the voice coding and compression algorithm used by the
DSPs on the IP trunk card. The G.XXX series ofcodecs are standards
defined by the International TelecommunicationsUnion (ITU). Different
codecs have different QoS and compression properties. The specific
codecs and the order in which they are to be used for codec negotiation is
configured in TM 3.1.
When configuring the IP Trunk 3.01 (and later) node in TM 3.1, select the
image containing the needed codecs, and the preferred codec negotiation
order. The final codec used is determined by the codec negotiation process
with the far end during call setup. Parameters can be configured for each
codec in an image.
IP Trunk3.01 (and later) suppor ts the following codecs:
G.711
G.729AB
G.729B
G.723.1
G.711 The G.711 codec delivers "toll quality" audio at 64 kbit/s. This codec is
optimal for speech quality,as it has the smallest delayand is resilient
to channel errors. However, it uses the largest bandwidth. The G.711
codec is the default codec if the preferred codec of the originating node
is not available on the destination IP Trunk3.01 (and later) node. Voice
Activity Detection/Silence Suppression is configurable through TM 3.1. An
ITG-Pentium 24-port trunk card supports 24 channels per card with G.711.
A Media Card 32-port trunk card supports 32 channels per card with G.711.
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.