374 OA and M using the ITG shell CLI and overlays
When prompted to login, enter the default username and password
as:
VxWorks login: itgadmin
Password: itgadmin
ITG>
6If this card is Leader 0, use the setLeader command:
ITG> setLeader xxx.xxx.xxx.xxx, yyy.yyy.yyy.yyy,
zzz.zzz.zzz.zzz and press Enter.
where
xxx.xxx.xxx.xxx is the IP address of the ELAN network interface
on Leader 0.
yyy.yyy.yyy.yyy is the gateway IP address for the ELAN network
interface on Leader 0. If the TM 3.1 PC is connected directly to
the LAN and there is no ELAN network interface gateway,then
the gateway IP address is "0.0.0.0".
zzz.zzz.zzz.zzz is the subnet mask for the ELAN network
interface on Leader 0.
7Do not leave the card with the default user name and password.
"Change the default ITG shell password to maintain access security"
(page 371)
8Configure all the IP trunk cards in the same node with the same
password. Repeat this procedure for other cards in the IP Trunk
3.01 (and later) node.
—End—
Download the ITG operational measurements through the ITG shell
The ITG operational measurements file contains counts of incoming and
outgoing calls, call attempts, calls completed, and total holding time for
voice and fax calls. Todownload this file from the TM 3.1 PC to the IP trunk
card, at the ITG shell prompt, type the following:
currOMFilePut <hostname, username, password, directory path,
filename> for the current file
or
prevOMFilePut <hostname, username, password, directory path,
filename> for the previous file.
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.