Configure IP Trunk3.01 (and later) data 227
ABTR (15) Range 0-30 Timer (in minutes) blocks the disconnect from being
tandemed across to the target node. Default value: 15
minutes. This timer value can be added in increments of
1 minute.
VTRK (NO)YES YES = supports IP Peer facilities.
NODE <NodeID> Node ID associated with the Signalling Server dedicated
for 911P trunks.
IFC SL1 IFCis set to SL1 by default if M911P is set to YES. This
prompt is not configurable.

If the DTI and PRI2 packages are restricted and the VTRK prompt is set

to NO, SCH2160 is printed on the TTY and VTRK is reprompted. Only

PRI/PRI2 is supported for 911P routes, and if DTI and PRI2 packages are

restricted, VTRK should not be set to NO.

Configure Media Card 32-port and ITG-Pentium 24-port trunk cards andunits for IP Trunk Route

Use LD 14 to configure the Media Card 32-port and ITG-Pentium 24-port

trunk cards and units. Record the first CHID for each IP trunk card on the IP

Trunk3.01 (and later) Installation Summar y Sheet.

LD 14 Configure Media Card 32-port and ITG-Pentium 24-port trunk cards and units
Prompt Response Description
req NEW/CHG/OUT
REQ NEW XX Add new data, where:
xx = 1 – 24 for ITG-Pentium 24-port trunk card
xx = 1 – 32 for Media Card 32-port trunk card
When using REQ = NEW XX, configure only one IP trunk
card at a time.
When using REQ = NEW XX, CHID is incremented for
each of the new units created.
It might be necessary to configure partial IP trunk cards due
to WAN traffic capacity limitations, or Leader and DCHIP
card real-time capacity for very large nodes and networks.
TYPE TIE
TN XX XX Terminal number
l s c u Format for Large System, Call Server 1000E, and Media
Gateway 1000E, where l = loop, s = shelf, c = card, u = unit
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.