480 Appendix G Upgrade an ITG Trunk1.0 node to support ISDN signaling trunks
7Log into the ITG shell.
At the ITG>prompt, enter clearLeader
"xxx.xxx.xxx.xxx", "yyy.yyy.yyy.yyy",
"zzz.zzz.zzz.zzz"
(see notes in step 2). The ITG shell outputs value = 0 = 0 x 0 to
indicate successful completion of the clearLeader command.
Enter clearLeader command even when removing configuration
files from Follower cards.
—End—
Step 2 - TransmitITG Trunk 2.0 software to the ITG 8-port trunk cards
Follow the steps in Figure 96 "New ITG Node Configuration tab window with
Leader 0 provisioned" (page 306) to transmit the ITG Trunk2.0 software to
the ITG 8-port trunk cards.
Procedure 83
TransmittingITG Trunk 2.0 software to the ITG 8-port trunk cards
Step Action
1Launch TM 3.1. Double-click ITG Meridian 1 IP Trk in the Services
folder.
2In the IP TelephonyGateway window, select Leader 0 from the ITG
trunk node that is being upgraded.
3Select menu Configuration > Synchronize > Transmit. The
ITG-TransmitOptions window appears.
4Make sure to set the radio button to Transmitto selected nodes.
Check the Card Software check boxonly.
5Locate the ITG28xx.mms software file on the TM 3.1 PC.If the path
to the ITG28xx.mms software file is known, type the path information
in the Software field. Or click the Browse button to find and select
the file. Click the Open button in the Browser so that the software
path and filename appear in the Software field in the ITG-Transmit
options window.
6Click the Start Transmit button.
Monitor progress in the Transmitcontrol window. Confirm that
the card software is transmitted successfully to allthe ITG 8-por t
trunk cards. The window identifies the cards by their TNs.
If the message in the control window indicates the software
transmit is unsuccessful, do not press Cancel. Leave the
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.