310 Provisioning IP Trunk3.01 (and later) in TM 3.1
17 Click the Ports tab. See Figure 100 "New ITG Node Ports tab"
(page 310).
Figure 100
New ITG Node Ports tab
18 This tab is only present for IP Trunk3.01 (and later) nodes. Use
the drop-down list to select the RTP port starting value. There are
two options, as follows:
•2300 – default value
•17300 – used for Cisco RTP header compression
Alternatively,enter any even-numbered port starting value between
1024 and 65534.
WARNING
Entering a starting port value other than 2300 or 17300
doesnot block calls, but can result in unexpected behavior,
as certain port ranges are reserved by the IETF.
Cisco header compression can be used only if a starting
port value is entered that is equal to or greater than17300.
Click the Restore Default button to restore the default port start
value.
Add the node
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.