Philips V24CT, V26CT manual Parameter Settings Transfer Messages, Message Condition Action required

Parameter Settings Transfer Messages

Parameter Settings Transfer Messages

The following messages related to Parameter Settings Transfer can appear on the display:

Message	Condition	Action required
(Parameter name)	The indicated parameter	Insert a module that has
no settings	module is not a T	a T on the front.
transfer capability	module.
(Parameter name)	No settings are stored in	Enter the parameter
check settings''	the module, or the	Task Window and check
	settings are incorrectly	the settings. The
	stored.	settings are
		automatically stored
		when you exit the Task
		Window.
Check Patient	The patient category	Either change the
Category and	stored with the settings	patient category for the
(parameter name)	in the module is	monitor or change the
settings	different from that of the	parameter settings.
	monitor.
(Parameter name)	The parameter module	Press		,
			Silence Reset
unable to store	was removed before the	re-insert the module and
settings in module	settings could be stored,	check/adjust the
	or there is a malfunction	settings in the
	in the module. (This	parameter Task
	message can appear with	Window. Exit the Task
	Settings Transfer On or	Window and leave the
	Off.)	module in the rack for
		about 10 seconds before
		you remove it. If the
		same message appears,
		replace the module.

Setting up your Monitor

Setting up your Monitor 3-63