Philips V24CT, V26CT manual Setting up the Parameter Modules

Setting up the Parameter Modules

Setting up the Parameter Modules

1.Decide which parameters you want to monitor.

2.Make sure the appropriate modules are plugged into the rack. If not, insert the module into the rack until the lever on the base of the module clicks into place. To remove a module, press the lever upwards and pull the module out. (See diagram below.)

3.Check that you have the correct patient cables and transducers plugged into the modules. The module connectors are color-coded to the patient cables and transducers, for easy identification.

Your monitor may have Parameter Settings Transfer set ON. To understand the effect this has when using modules with the “T” label, turn to Parameter Settings Transfer in Chapter 3.

Getting Started

Getting Started 2-5