Philips V26CT, V24CT manual Hardkey, Functions

The CMS and V24 and V26 Patient Monitors

Introduction
Hardkey						- press to silence an alarm or alarms that are sounding
	Silence/Reset
Functions	or, if alarms are latching, to reset them.
			- press to suspend or switch on all alarms. The current state
	Suspend
	is indicated by the Alarm Suspend Lamp.
					- press to return to the main monitoring screen.
	Main Screen
							- (CMS only) press to change between screen layouts
	Change Screen
	or to access a 2nd or 3rd display. You can also freeze any wave
	movement on the screen (INOPs, alarms and numerics are not affected).
							- press to record pre-selected waves onto a system
	Realtime Record
	recorder or a bedside recorder.
							- press to record pre-selected waveforms that are no
	Delayed Record
	longer on the monitor screen.
		- press to enable you to suspend or switch on alarms, set and
	Alarms
	review alarm limits, enter Monitor Standby, or set the alarm volume.
						- press to enable you to view data from other beds in
	Other Patients
	your group.
						- press to enable you to pre-select certain system
	Monitor Setup
	characteristics.
				- press to enable you to set up and perform procedures
	Procedures
	such as Cardiac Output, Wedge Pressure (CMS only), ST analysis, Drug
	Calculations, admit and discharge patients, or end a particular patient
	case and transfer patient data.
						- press to enable you to view vital signs and graphical
	Trends/Calcs
	trends, make and review calculations, print reports and mark events to
	view in graphs.
						- press to enable you to change or adjust parameter
	Module Setup
	settings, switch parameters on or off, or set up parameters.
		Keys
	Arrow

1-12 The CMS and V24 and V26 Patient Monitors