Philips V26CT, V24CT manual Connectors

Monitor Installation and Patient Safety

Controls and Connectors

2.V AMP; this is the vertical amplitude control used to adjust the height of the displayed video.

3.V SHIFT; this is the vertical shift control used to adjust the vertical position of the displayed video.

4.H AMP; this is the horizontal amplitude control used to adjust the width of the displayed video.

5.EAST WEST; this control is used to adjust the pin-cushion effect of the displayed video.

Connectors of	1.	There are two fuse holders for the line protection fuses. The fuses
the M1092A,		depend on the type of monitor and the power supply as
M1094A and		summarized below:
M1094B		200-240V M1094A color monitor	2.5A 250V
Displays
		200-240V M1094B color monitor	3.15A 250V
		200-240V monochrome monitor	2A 250V
		100-120V color or monochrome monitor	4A 125V
			(Slow-Blow)
	2.	Local Power Connector; a 3-pin connector is used to input the
		local line voltage.
	3.	System Power Connector; a 15-pin “D” type connector is used to
		output 60V DC (100W max) to a similar connector on the DC/DC
		converter in the rear of the computer module.
	4.	Video In Connector; a 9-pin “D” type connector is used to input the
		video signal to be displayed from the display controller in the
		computer module (DSPC for monochrome or CDSPC-Video for
		color).
	5.	Video Out Connector; a 9-pin “D” type connector is used to output
		the video signal to be displayed on a duplicate display.

11-26 Monitor Installation and Patient Safety