Philips V26CT, V24CT manual Monitor Setup Monitor Revision → Show SW Rev

Indications for Use

•Replacement Parts - It is highly recommended that only Philips Medical Systems recommended parts and accessories be used with this equipment. Failure to do so may result in the degradation of performance. Accessories and parts for individual modules and components are listed at the back of the appropriate section in this manual.

Note—A note gives special instructions to highlight an operating procedure or practice. Notes may precede or follow the applicable text.

At this time, Philips Medical Systems will make available on request, and in English only, such circuit diagrams, component part lists, descriptions, calibration instructions, or other information which will assist the user's appropriate qualified technical personnel to repair those parts of the equipment which are classified by Philips Medical Systems to be repairable. A list of Philips Sales and Support Offices is provided at the end of this manual.

Notice to the User

Although there may be products in your area that look similar to the Philips M1165/66/67/75/ 76/77A CMS Patient Monitoring System and the Philips M1205A V24 and V26 Patient Monitors, their functionality may not be the same. This User's Reference Manual is intended to be used with the Philips M1165/66/67/75/76/77A CMS Patient Monitoring System, the M1026A Anesthetic Gas Module and the Philips M1205A V24 and V26 Patient Monitors only.

This Manual is only applicable for Release C.1 versions of the CMS monitors and for Release

D.0 of the V24 and V26 monitors. A Release C.1 or Release D.0 monitor can be identified by:

a. the Release C.1 or D.0 label on the monitor, or

b. the suffix of the EPROM pack part number. To view this number, press
Monitor Setup	→	Monitor Revision →	Show SW Rev

The suffix of the EPROM pack part number on a Release C.1 CMS is E. The Software Revision of a Release D.0 V24 or V26 monitor is M.00.03

x