Philips V24CT, V26CT manual Changing the Recorder Speed Continuing Timed Recording, Display

Realtime Record

Changing the Recorder Speed

Changing the Recorder

Continuing

aTimed Recording

Additional Information

The recording speed can be changed for delayed, realtime, and oxyCRG recordings made on a bedside recorder. Changes made in the Change Recording Speed window affect only the last requested and running recording.

Note—If more than one bedside recording is running, the Change Recording Speed window affects only the last requested and running recording. However, if the last requested recording is stopped, the Change Recording Speed window then affects the recording that started running before the stopped one.

Because the recorder must complete the annotation at the beginning of the strip before the key to access this window appears, there may be a wait of a few seconds before the speed can be changed. For delayed recordings, access to the Change Recording Speed window is through the key. The new speed is not stored.

The speed of alarm recordings cannot be changed; these recordings always run at 25 mm/sec.

You can change the recorder where alarm, delayed, preset, or realtime non-configured recordings are made.

1.Press Monitor Setup .

2.Press Recordng Setup .

3.Select the recording type (Delayed & Alarm, Mode, or Procedure).

4.Press Change Recorder to choose the appropriate recorder.

Press	CONT	on the recorder. The recording runs until you stop it (by
pressing the			on the recorder or the		softkey on
		STOP		Stop Recordng
the display).

Recording Functions 6-43

Recording Functions