Philips V26CT, V24CT manual Inserting a, Calibration, Signal, Layouts

Recording Functions

Additional Information

Inserting a	You can insert a calibration signal into the waveform display on the
Calibration	monitor and into any actively running recording. Calibration signals are
Signal	automatically generated for calibrated waves. The signals can then be
	used to determine the amplification of the waveform.
	To insert the signal, press					, then			. If you
					Trends/Calcs			Mark Event
	press the			softkey at the bottom of the screen, when a
		Cal Signals
	recording is being run, the signal appears on the display and is inserted
	in the recording. Refer to Chapter 3, “Setting up your Monitor” for
	further details.
Recording	Layout Choices on Recorder M1116A/B
Layouts
	Layout		Sector 1				Sector 2
	#11		20 mm				20 mm
			Wave 1				Wave 2
	#2		40 mm
			Wave 1,2
	#3		20 mm				20 mm
			Wave 1				Wave 2,3;
	#4		40 mm
			Waves 1-3

1Alarm recordings always use layout #1, even if the delayed recordings are configured with layout #2, 3, or 4.

6-44 Recording Functions