Philips V24CT, V26CT manual Operating In the Event Setup task window you can, Selecting

Adjusting Neonatal Event Review Settings

Desaturation	Alarm Triggered
Event Settings	The Desaturation events are derived from the first SpO2 bedside module
	and triggered either by a Red*** Desat alarm or a Yellow** low limit SpO2
	alarm. The Desat/SpO2 alarms and trigger times can be viewed but not
	adjusted in the Event Setup task window. These settings must be adjusted
	in Monitoring Mode in the SpO2 task window. If the SpO2 alarm related
	trigger threshold and trigger time items are selected, the
		key is inactive and the following status message is
	Change Content
	displayed in the Event Setup task window:
	• “SpO2 items must be changed in the SpO2 Setup”
	User Defined
	For situations where the storage and documentation of an event should
	be independent of all Desat/SpO2 alarms, you can adjust the Desaturation
	event threshold and trigger time in Monitoring Mode in the Event Setup
	task window.
	Desat Trigger Off
	It is also possible to turn the Desaturation event triggers OFF in cases
	where the occurrence of Desaturation events are so frequent that the
	event storage facility risks becoming full (a total of 48* events can be
	stored). If the Desaturation event trigger is switched to OFF, the oxygen
	saturation is still displayed in the oxyCRG Episode task window but the
	Desaturation events are not captured or displayed in the Event Review
	task window
	*24 for V24 and V26 Patient Monitors

Operating In the Event Setup task window you can:

Controls

1.Select items.

2.Change the item content.

Selecting	Selecting the	Select Item	softkey enables you to step through the items
Items	listed under each event group.

Neonatal Event Review

Neonatal Event Review 9-21