6Insert and punch down (connect the wires of the spooled cable into the cutdown section of the adapter next to the label for wiring run 1 in the jack field (the top jack in the box labeled ❑
7Run the other end of the cable to the voice terminal location where wiring run number 1 ends. Use cable clips and/or staples to attach the cable along walls, baseboards, and moldings.
8Run the rest of the cables consecutively from the connections in the jack field to the corresponding voice terminal locations.
Follow this procedure to terminate wiring runs in modular wall jacks.
1At the voice terminal location for wiring run number 1, mark the place on the wall where you want to put the modular wal1 jack.
2Trim the excess cable, leaving enough so that about 4 inches extend beyond the outline of the modular jack you drew on the wall.
3Loosen the screw that holds the cover of the wall jack in place, remove the cover, and set the cover and screw aside.
4Using the cable termination tool, remove about 2 inches of the cable’s jacket. This exposes the color- coded twisted pairs of wires inside the jacket.
5Thread the cable from the bottom of the jack up through the center until the exposed wires and 1/4 inch of the cable’s jacket come through next to the center post on the jack.
