AT&T 518-600-016 manual Setting Options, Follow the appropriate procedure below to identify

Setting Options

IDENTIFYING MUSIC- ON-HOLD LINE JACK

If the MERLIN II system has Music-on-Hold, you need to identify the control unit line jack to which the music source is connected. Remember that the Music-on-Hold line can't be placed in a line pool, assigned to a voice terminal, used for Loudspeaker Page, or used as a Direct Inward System Access (DISA) line.

NOTE: If you have a pooled system, you must remove the line designated for Music-on-Hold from the main pool, where it is assigned by default before you can identify it as the Music-on-Hold line. If you haven't already done so, follow the instructions under “Assigning Lines to Line Pools” on page 3-32, then continue with this procedure.

Follow the appropriate procedure below to identify the

Music-on-Hold .line jack.

With a Display Console

1Enter administration mode by sliding the TIP switch to P.

2Press Conference twice.

The administration menu appears.

3Press [More], [Options], [Music].

4The system prompts you to indicate the Music-on-Hold

line jack by pressing the appropriate line button. Each successive press of a button gives you one of the following codes:

Green light on = jack is assigned for Music-on-Hold

Green light off = jack is for a standard line or loudspeaker page

5Press Conference to return to the administration menu or leave administration mode by sliding the T/P switch to the center position.

Administering a New System 3-45