AT&T 518-600-016 manual Enter administration mode by sliding the T/P switch to P

CHANGING SYSTEM TYPE

6 Continue administration or leave administration mode by sliding the T/P switch to the center position.

If you change the system type (square, pooled, or behind- switch), you delete all system line administration and voice terminal programming formerly in place. You'll have to reassign the lines and reprogram all the voice terminals, since this change resets them to the default configuration. Check Form 1e, System Form- Requirements and Options for Release 3 or the System Configuration Form for Feature Module 2 to determine the system type: square, behind-switch, or pooled. (The default setting is pooled with Button Access to Line Pools.)

If the system is to be pooled, determine the method to be used to access line pools: Button Access, Dial Access, or Automatic Route Selection (ARS). If you change it from Button Access to either Dial Access or Automatic Route Selection (ARS), the system automatically assigns a different function to the two buttons above Intercom- Voice on voice terminals. If the system is administered for Dial Access or ARS and you change it to Button Access, the system assigns the main pool to the two buttons above Intercom-Voiceon voice terminals. The system automatically removes the main pool from any other buttons to which it was assigned at voice terminals throughout the system.

NOTE: Be sure to record the changes on the appropriate planning forms.

With a Display Console

1 Enter administration mode by sliding the T/P switch to P.

2 Press Conference twice.

The administration menu appears.

3-66 Administering a Changed System