Installing a Basic Telephone Module
CONNECTING A PRINTER TO THE CONTROL UNIT
If you are installing a Basic Telephone Module, you also
need to install a Frequency Generator in the Power Supply Module. A Frequency Generator is required for each carrier that has one or more Basic Telephone Modules. If possible, place all Basic Telephone Modules on the same carrier. For additional information, refer to the procedure, “Installing a Frequency Generator in the Power Supply Module,” on page
NOTE: Basic Telephone Modules are not intended for use with an IROB.
Install the Basic Telephone Modules as follows:
1Review Form lc, System
2Install the Basic Telephone Modules on the carrier.
A printer (AT&T models 475/476, 572) can be connected to the control unit through the SMDR port on the Processor Module.
NOTE: The AT&T 570 printer is not compatible with the MERLIN II system because it is not a serial printer.
The following items are required for installation:
●EMI Filter (Z200A)
●Adapter (355AF) for male connector on interface cable or
●Adapter (355A) for female connector on interface cable
