AT&T 518-600-016 manual To program a pause, press Hold To program a stop, press Drop

4To program other features, you must dial ✱✱ to exit Automatic Line Selection. Dialing ✱✱ applies only to exiting the Automatic Line Selection programming routine. Otherwise, leave programming mode by sliding the T/P switch to the center position.

NOTE: Digital phones: Dial #00.

Rapid Dialing

There are three features that can be programed onto voice terminals to allow the user to rapidly dial calls; Outside Auto Dial, Last Number Redial, and Saved Number Redial.

Outside Auto Dial An Outside Auto Dial button can be used to dial telephone numbers, account numbers, and PBX, Centrex, or Custom Calling feature codes, with one touch. To program an Outside Auto Dial

these steps:

1Label a button.

2Enter programming mode by sliding the T/P switch to P.

NOTE: Digital phones: Dial #33.

3Press the button you want to program.

4Dial ✱ 90 and, if required, a Pool Access number and two pauses (press Hold twice) plus a telephone number or a PBX or Centrex code.

5You may need to program a pause, stop, or switchhook flash into an Outside Auto Dial sequence, or you may need to switch from rotary to Touch-Tone signals in the middle of a programmed dialing sequence. To do so, you must enter the following special character when you program the sequence.

>To program a pause, press Hold.

>To program a stop, press Drop.

3-118 Programming Voice Terminals