Connecting Voice
Terminal Wiring
Directly
2 Wire the station jacks on the modules to the jack field using D8W cords. Thread the wires through the wire manager located at the base of each module as you connect them to the station jacks. Label each end of each wire with the intercom number to which it connects. Remember, the intercom numbers do not necessarily match the jack numbers. Intercom 10, for example, is connected to station jack 01 on the first station module of the control unit.
3 Record the end location of each intercom number on
the system directory label and put this label on the inside of the front cover of the control unit.
Complete wiring instructions for data stations are found in the separate document, MERLIN II Communications System Data Communications Guide.
To connect the voice terminal locations directly to the control unit, perform the following steps:
1 Number every station jack on the modules sequentially from 01 through 120, using the station numbering strips. Begin with the module in slot 1 and number from bottom to top; then go on to the next module with station jacks, working from left to right across the control unit modules.
You may want to review Figure
2 In the system directory, fill in the voice terminal location you have selected for each intercom number.
Wiring the System |
