AT&T 518-600-016 manual Moving a Voice Terminal

MOVING A VOICE TERMINAL

2If the voice terminal locations connect to the control unit through a jack field, install a wiring run for each new voice terminal location according to the instructions in “Jack Field Wiring,” on page 2-33. If the voice terminals connect directly to the control unit, see "Connecting Voice Terminal Wiring Directly" on page 2-25.

3To connect the new voice terminal to the system, see the instructions in “Connecting the Voice Terminals,” on page 2-92.

4Record the new information in the system directory and on the appropriate planning form. For Release 3, record this information on Form 1d, Systern Form– Station Planning and the appropriate Station Configuration form (Form 3b, Form 3c, Form 3f, or Form 3g). For Feature Modules 1 and 2, record this information on the Master Planning Foirm, Station Jack section and the appropriate Station Configuration Form.

You can easily move a voice terminal from one location to another within your system without having to reprogram the voice terminal.

To move a voice terminal, do the following:

1Make sure the necessary wiring is in place at the new location (see "Voice Terminal Wiring" on page 2-23). Check Form 1d, System Form–Station Planning for Release 3 or the Master Planning Form for Feature Modules 1 and 2 for the number assignments.

2Unplug the voice terminal at its old location, and plug it in at its new location.

Modifying the System 2-115