AT&T 518-600-016 manual 5Press Lines, pools

Refer to Form 1a, System Form- Incoming Lines and/or Form 1b, System Form-Tie Lines for Release 3, and the Master Planning Form, Line Jacks for Feature Module 2 which shows how each line jack should be administered. Follow the steps below to add or remove lines from the main pool. If a line should be assigned to a different line pool, perform that step as well.

With a Display Console

1Enter administration mode by sliding the T/P switch to P.

2 Press Conference twice.

The administration menu appears.

5Press [Lines], [pools].

4 Dial the pool code (the default codes are 9 for the main pool and 890 through 899 for the other pools).

5 Press [Enter]

6 Press the line buttons until the appropriate code shows for each line:

Red light on = the line is assignd to the pool

Red light off = the line is not assigned to the pool

7 Press[Exit], and repeat steps 4 through 6 to administer any other line pools.

8 Press Conference to return to the administration menu or leave administration mode by sliding the T/P switch to the center position.

With a BIS-34D Console

1 Enter administration mode by sliding the T/P switch to

P.

2 Press Conference twice.

Lights flash next to Adm Tel, Adm Pool, Message, and Speaker.

3-34 Administering a New System