Follow the appropriate procedure below to renumber the system. Be sure to update all of the planning forms that are affected by the replacement or addition of a module.
With a Display Console
1Enter administration mode by sliding the T/P switch to P.
2 Press Conference twice.
The administration menu appears.
3From the administration menu, press [System], [More],
[Renumber] .
YOU see the message, “System is restarting. ..” When the
renumbering is complete, the administration menu appears on the
display.
4Press Conference to return to the administration menu or leave administration mode by sliding the T/P switch to the center position.
With a BIS-34D Console
1Enter administration mode by sliding the T/P switch to P.
2 Press Conference twice.
Lights flash next to Adm Tel, Adm Pool, Message, and Speaker.
3Press Message.
4Dial #299.
Lights next tO Adm | Tel, Adm Pool Message, and | Speaker | begin | |||
to flash. You | hear | two beeps and then | see the message, | ‘System is | ||
If | only the light next to | Message | flashes, | one | or | |
more calls are in | progress and the procedure is | not executed | until | |||
the light becomes steady.
5Continue administration or leave administration mode by sliding the T/P switch to the center position.
