With a Display Console

1Enter administration mode by sliding the T/P switch to P.

2Press Conference twice.

The administration menu appears.

3Press [More], [More], [Data], [Voe/Data]

4Assign voice/data pairs by pressing the appropriate

Auto Intercom-buttons. Each successive press of a button gives you one of the following codes:

Green light on= voice terminal is in a voice/data pair

Green light off = voice terminal is not paired

5Press Conference to return to the administration menu or leave administration mode by sliding the T/P switch to the center position.

With a BIS-34D Console

1Enter administration mode by sliding the T/P switch to P.

2Press Conference twice.

Lights flash next to Adm Tel, Adm Pool, Message, and Speaker.

3Press Message.

4Dial #211

Green light next to Message comes on steady and two beeps sound.

5 Press either one of two adjacent Auto Intercom buttons:

Green light on = station jack part of voice/data pair

Green light off = station jack is not paired

6Press Message.

7Continue administration or leave administration mode by sliding the T/P switch to the center position.

Administering a New System 3-49

Page 257
Image 257
AT&T 518-600-016 manual Assign voice/data pairs by pressing the appropriate, Dial #211