AT&T 518-600-016 manual Dial the new Flexible Number code Press Enter

4Press [Single] .

5Press the appropriate button for the type of dial code

you want to change. The choices are the following:

[Station] [Pools] [Page Zns] [GrpCall]

6Take one of the actions below to indicate the “old” dial code.

NOTE: The third action can only be used for lines or stations.

>Dial the current number of the line, station, line pool, or group.

>Dial the logical ID number. Be sure to enter the pound sign (#) before the number.

NOTE: Logical ID numbers run from lowest to -highest, with the lowest number being #1. For example, to specify line pool 9, you would enter "#l ." Pool 890 is #2, Pool 891 is #3, etc. Note that logical ID numbers for lines and stations are preprinted on the administration overlay.

> If you’re identifying a line or station, press its line button or Auto Intercom button.

The light next to the button goes on.

7Press [Enter]. .

The display shows the old number and prompts you to enter the new number-

8Dial the new Flexible Number code.

9Press [Enter]. .

The system reiurns you to the Single Renumber screen.

10Press Conference to return to the administration menu or leave administration mode by sliding the T/P switch to the center position.

Administering a New System 3-31