AT&T 518-600-016 Administering Stations, Dial #302 Press line buttons for the selection you want

With a BIS-34D Console

1Enter administration mode by sliding the T/P switch to P.

2 Press Conference twice.

Lights flash next to Adm Tel, Adm Pool, Message, and Speaker.

3Press Message.

Green light goes on steady and two beeps sound.

4Dial #302

5Press line buttons for the selection you want:

Green light on = Touch Tone selected

Green light off = rotary seiected

6Press Message.

7Continue administration or leave administration mode by sliding the T/P switch to the center position.

Administering Stations

ASSIGNING LINES TO STATIONS

After you have administered lines or line pools, you must

assign them to stations. If you are assigning dial access to line pools, see “Assigning Lines to Stations for Dial Access to Pools” below. Refer to Form la, System Form-Incoming Lines for Release 3, or the System Configuration Form for Feature Module 2 for proper assignments.

Assigning Lines/Line Pools to Stations for Square, Button- Access, and Behind Switch Systems

The following procedure can be used for assigning lines or line pools for a square, button access, or behind-switch system.

3-36 Administering a New System