AT&T 518-600-016 manual Preinstallation Requirements

Preinstallation Requirements

REVIEWING THE	Review the completed system planning forms, which
PLANNING FORMS	should be on site, before starting installation. The forms
	for Release 3 are titled:
	● Form la, System Form—Incoming Lines
	● Form 1b, System Form—Tie Lines
	● Form 1c, System Form—Module Identification
	Diagram
	● Form 1d, System Form—Station Planning
	● Form 1e, System Form—Requirements and Options
	The forms for Feature Modules 1 and 2 are titled:
	● Master Planning Form
	● System Configuration Form
	You should be familiar with the entire layout of the system
	including wiring, jack field, network interface, and
	accessory requirements. If the system has data hardware,
	see the separate manual, MERLIN II Communications
	System Data Communications Guide, for complete
	instructions for installing data equipment.
ENVIRONMENTAL	The control unit should be operated in an environment that
REQUIREMENTS	meets the following conditions.
	● Operating temperatures. The operating temperature
	should be 40 to 1040F (4 to 400C). Optimum
	operating temperature is 600F.
	● Humidity. The humidity should be between 20 and 80
	percent.
	● Airborne contamination. Do not expose the control
	unit to moisture, corrosive gas, dust, chemicals, spray
	paint, or similar material.

Preinstallation Requirements 2-1