6Wrap the jacketed cable around the center post until the colored wires extend over the two plastic caps.
7Align the cable in one of the notches on the jack, and attach the jack to the wall. One type of jack requires screws, while another uses adhesive backing.
8Remove the two plastic caps on the adapter (this exposes the grooved connecting block), and set the caps aside. They are used instep 10.
9Insert the colored wires into the grooves from left to right. See Table
10Align the caps over the grooved block and press them down firmly until they snap into place.
11Trim any colored wires protruding from the plastic caps. When you‘re finished, none of the wires should extend far enough beyond the plastic caps to touch each other.
12Put the cover on the adapter and tighten the screw.
13Attach the blue wiring run label for this voice terminal location ( ❑ 1) to the cover.
14Connect the rest of the wiring runs from the jacks in the jack field to the voice terminal locations in the same way, making sure that both ends of each wiring run are labeled identically.
15When you have completed the wiring runs, use cable ties and clips to bundle the cables at the jack field to reduce cord clutter, and then close the doors on the apparatus boxes.
You should now have a properly installed and labeled jack field with building wiring connecting the voice terminal locations to the control unit location.
