SELECTING THE SIGNAL TYPE
NOTE: If the tie line is
6 Repeat steps 4 and 5 for each incoming tie line port.
7 Press [Exit] and select [OutType] of [InType] to select the outgoing line type repeat steps 4 and 5 for each outgoing tie line port.
The out type screen appears.
8 Press Conference to return to the main administration menu, or leave administration mode by sliding the T/P
switch to the center position.
To select the signal type for tie lines, follow these steps:
1Enter administration mode by sliding the T/P switch to P.
2Press Conference twice.
The administration menu appears.
3Press [More], [More], [More], [TieLines], [E&Msgni].
The E&M signal screen appears.
4Dial the line number or press the line button of a tie line, then press [Enter] .
5Press the button beneath the display to select the type of signal wanted:
>Type1S =Type 1 Standard (default) >TypelC=Type 1 Compatible
>Type5=Type5 Simplex
The E&M signal screen appears.
6Repeat steps 4 and 5 for each tie line port.
7Press Conference to return to the main administration menu, or leave administration mode by sliding the T/P switch to the center position.
