AT&T 518-600-016 manual Administering Basic Telephones

5Use either Centralized Programming to program the basic telephone or connect a voice terminal directly to the control unit station jack where you plan to connect the OPTI, BTMI, or BTMI-2. To use centralized Programming, follow the procedures on page 3-81for a Display Console or page 3-100for a BIS-34D Console.

6To change the order in which the system searches for an available line, follow the “Automatic Line Selection” procedure on page 3-117. Do not include intercom lines in the sequence.

7Set Ringing Options on lines and line pools. To do this, follow the “Ringing Options” procedure on page 3-114.

8Remove any custom features assigned to buttons above the dial pad.

9Disconnect the voice terminal or leave Centralized Programming.

10Leave administration mode by sliding the T/P switch to the center position.

11Connect the basic telephone to the OPTI, BTMI, or to the BTMI-2.

12Connect the OPTI, BTMI, to the BTMI-2 or the basic telephone port selected and connect the BTMI or BTMI-2 to the analog port selected.

Administering Basic Telephones 3-113