A backboard should be in place at the location where you
plan to install the control unit. If no board is ready, see “Wall Attachment Requirements” on page
backboard is in place, do the following:
1Mark positions on the backboard mounting surface for the control unit and the jack field in relation to each other. Also note the locations of the ac outlet and the network interface (see “Installing the Control Unit” on page
2Attach a blue label ( ❑
3Attach the apparatus boxes to each other by meshing the tongues and grooves. Position the boxes so that the doors with the handles are on the right. Use only as many boxes as you need.
4Fasten the apparatus boxes to the mounting surface with screws.
5Snap into the boxes as many modular jack adapters as you need, filling the boxes from top to bottom.
●If one of the jacks on the adapter has a black dot on it, make sure that the jack with the black dot faces to the right.
●If you use
CONNECTING VOICE | Once you have constructed a jack field, connect the voice |
TERMINAL WIRING | terminal wiring to the field as described in the following |
TO A JACK FIELD | topics: |