AT&T 518-600-016 manual To the center position, Planning.Form for Feature Module 2. The form shows

	6 Press Message.
	7 Press Conference to return to the administration menu
	or leave administration mode by sliding the T/P switch
	to the center position.
IDENTIFYING JACKS	Refer to Form 1d, System Form-Station Planning for
FOR THE VOICE	Release 3, or the Station Jacks section of the Master
ANNOUNCEMENT TO	Planning.Form for Feature Module 2. The form shows
BUSY VOICE	which analog voice terminals, if any, have been assigned
TERMINAL FEATURE	two station jacks so that the Voice Announcement to Busy
	Voice Terminal feature can be used.
Considerations	● You must assign two consecutive analog telephone
	jacks on the control unit to the voice terminal. The
	first jack must have an odd jack number (even
	intercom number) and the second jack the next higher
	even jack number (odd intercom number). The
	intercom number for the phone is the even intercom
	number.
	● You can assign a phone either the Voice
	Announcement To Busy Telephone feature or the
	Simultaneous Voice and Data feature but not both.
	● This feature is not available with basic telephones.
	Follow the appropriate procedure below to identify any
	station jacks in voice/voice pairs.
	With a Display Console
	1 Enter administration mode by sliding the T/P switch to
	P.
	2 Press Conference twice.
	The administration menu appears.
	3 Press [Stations], [More], [More], [VceSgnl].

Administering a New System 3-43