SETTING SYSTEM TYPE
5 Dial number to designate system size:
0 = small
1 = large
The message “System is
renumbering is complete, after a short delay, the lights flash next
to Adm Tel, Adm Pool, Message, and Speaker.
6 Continue administration or leave administration mode by sliding the T/P switch to the center position.
Refer to the System Configuration Form for Feature Module 2 or Form 1e, System Form- Requirements and Options to determine the system type: square, behind- switch, or pooled. If the system is to be pooled, determine the method to be used to access line pools: Button Access, Dial Access, or Automatic Route Selection
(ARS)..
With a Display Console
1Enter administration mode by sliding the T/P switch to P.
2Press Conference twice.
The administration menu appears.
3Press [System], [Type].
The type screen appears.
4Press the appropriate button:
>For a square system, press: [Square],
>For a pooled system, press one of the following:
[ButnAcc], [ARS], [DialAcc].
>For a behind switch system, press [More],
[BehindSw].
The message “System is
administration menu after a short delay.
