AT&T 518-600-016 manual With a Display Console

CHANGING	If you change a standard voice terminal station port to an
ATTENDANT	attendant position or vice versa, you have reassign lines
POSITIONS	and features to it, since all settings return to the default
	condition. Depending upon the equipment plugged into
	the port and the port’s new use, you may have to change
	the voice terminal or console and any attached accessory
	equipment.
	NOTE: Be sure to record the change on the appropriate
	planning forms.
	The station connected to jack 01 (default intercom number
	10) is an attendant position, and this cannot be changed.
	You can designate up to seven other analog attendant
	positions, two per analog station module.
	Keep in mind that there cannot be more than eight
	attendant positions. If you want to designate a new
	attendant position and the system ahead y has the
	maximum number, you must change an existing attendant
	position to a nonattendant voice terminal before you
	designate a new attendant position.

With a Display Console

1Enter administration mode by sliding the T/P switch to P.

2Press Conference twice.

The administration menu appears.

3Press [System], [Attendants] .

4Press [Position] .

A steady flashing green light appears next to each button for each station that either is or can be an attendant position. No light means the station cannot be an attendant position.

3-68Administering a Changed System