Testing for an Outside Line Dial Tone
TESTING INTERCOM CALLS
Testing lntercom- Voice
4 Pick Up the handset.
The green light next to the red light goes on and you hear another intercom dial tone.
5 Replace the handset.
1 Without lifting the handset, touch a line button.
The red light goes on next to this button.
2 Pick up the handset.
The green light to the red light goes on and you hear a dial tone.
3Replace the handset, and repeat Steps 1 and 2 for each line button on the voice terminal.
After you have performed the two tests, unplug the voice terminal cord from the jack at Intercom 10 (jack location
01)and plug it into the next voice terminal jack you are testing. Reconnect the jumper cord to Intercom 10. Repeat the two tests on every voice terminal jack on the control unit to verify both intercom and outside line dial tones.
When you are finished, make sure all the jumper cords are plugged in to the correct jacks on the control unit (match the number on the cord’s label with the number next to the jack on the control unit), and return the administrator/attendant console to its original location.
To make sure the system can be used to place intercom calls, perform this test from one voice terminal to another in the system. Make sure someone will answer the call.
1At any voice terminal in the system, touch the fourth button down in the leftmost column of buttons
The red light next to the button goes on.
Testing the System
