AT&T 518-600-016 manual Symptom a module doesnt work properly in a slot

MODULE DOESN'T		Symptom: A module doesn't work properly in a slot.
WORK
	Possible Cause		Possible Solution	To Investigate Further
	1. The module needs to be		To correct this problem, it is	If the module is correctly
	cleared of previous		preferable LO have a printer	administered for the system
	administration.		to check previous	and it still doesn’t work go to
			administration.	Possible Cause 2.
			If you have a printer:
			Enter administration mode
			and dial #905. The printout
			shows what type of module
			the operating system is
			expecting. If the module is
			not administered correctly
			for the system, follow
			instructions under
			“Renumbering After
			Replacing or Adding
			Modules” on page 3-63 to
			renumber the system.
			If you don’t have a printer	If the module is correctly
			to check previous	administered for the system
			administration:	and it still doesn’t work go to
			FOllow instructions under	Possible Cause 2
			“Renumbering After
			Replacing or Adding
			Modules”’ on page 3-63 to
			renumber the system. Note
			that by doing so you will lose
			all previous administration.
			If the module works, you
			have corrected the problem.
			Check your administration
			forms and readminister the
			system.

Procedures for Specific Symptoms 4-49