Administering a New System

SETTING SYSTEM SIZE

A MERLIN II system can be set for two different sizes: small and large. The small setting is for systems administered for eight or fewer lines. The large setting is for systems administered for more than eight lines. This large size setting allows the system to accommodate Up to 56 lines. Refer to the System Configuration Form for Feature Module 2 or Form 1e, System Form- Requirements and Options to determine the system size.

With a Display Console

1Enter administration mode by sliding the T/P switch to

P.

2Press Conference twice.

The administration menu apperas

3Press [System], [Size]

The size screen appears.

4 Press [Small] for a small system or [Large] for a large System.

You see the message "System is Re-starting..." The system

renumbers itself, then the administrationmenu appears on the

display

5Continue administration or leave administration mode by sliding the T/P switch to the center position.

With a BIS-34D Console

1Enter administration mode by sliding the T/P switch to P.

2Press Conference twice.

Lights flash next to Adm Tel, Adm Pool, Message, and Speaker.

3Press Message.

Light goes on steady next to Message. Flashing lights go off.

4 Dial #201

Two beeps Sound.

Administering a New System 3-21

Page 229
Image 229
AT&T 518-600-016 manual Administering a New System, Press Small for a small system or Large for a large System, Dial #201