AT&T 518-600-016 manual Lnitializing

lNITIALIZING

STATION POSITIONS (CHANGING INTERCOM NUMBERS TO MAKE SPACE IN THE DIAL PLAN)

3Press Message.

4Dial #999 and wait for the beep.

5 Press Message.

Wait until printing is complete before leaving administration mode. Don’t remove the printout until after you’ve Ieft administration mode or printing page alignments will be affected.

6Leave administration mode by sliding the T/P switch to the center position.

When the MERLIN II system is first setup, it assigns default dialing codes to stations, lines, line pools, and Call Distribution and Group Page Groups. See “Default Settings” on page 3-15. . -

NOTE It also assigns codes to agent splits for the Call Management System (CMS) that is available with Feature Module 2 only. For additional information, see the MERUN II Communications System System Manual for the Call Management System.

Because dialing plan numbers must be unique, the default dialing plan leaves few numbers available for use as Flexible Numbering codes. To make space available in the dial plan you need to perform the Initialize Station Position procedure.

This procedure renumbers the stations in the system so that they are all in the 7000 range by placing 70 or 7 before their default intercom numbers, i.e., 7010 through 7069 and 7700 through 7759. This saves you time and makes Flexible Numbering codes 1000 through 6999 available for use. To assign intercom numbers in the 7000 range to all stations and change default codes to lines, line pools, tie lines, Call Distribution Groups, and Group Page Groups:

3-28 Administering a New System