AT&T 518-600-016 manual General Tests, On a BIS-34D Display Console, touch Message and dial #200

General Tests

RESTARTING THE CONTROL UNIT

Administrative Restart

If you are experiencing a problem not described in the previous tests, or if none of the tests reveaI a specific problem, try the following procedures before calling the equipment supplier.

If the portion of the memory that maintains administration and station programming has been corrupted, the system may act abnormally. Restarting the control unit restores this part of the memory, which may solve the problem. (Restating the control unit does not erase administration or programmmg.)

There are two ways to restart the control unit. One is through an administration procedure, the other is through the control unit hardware.

To restart the system using an administrative procedure, dial a restart code by following these steps:

1Slide the T/P switch on the administrator/attendant console to P.

2Touch Conference twice.

3Choose the appropriate step for your console:

>On a MERLIN II System Display Console, touch

[System] , [Restart] .

>On a BIS-34D Display Console, touch Message and dial #200.

NOTE: When you restart the control unit by dialing a restart code, the Auto Answer-Intercom, Coverage Inhibit, Do Not Disturb, and Privacy features may get turned off, even though they are still programmed. To turn them back on, touch the button associated with the feature.

General Tests 4-55