AT&T 518-600-016 manual Planning forms, Press Small or Large for the system size wanted

CHANGING SYSTEM	If you change the system size designation from small to
SIZE	large, or vice versa, the system reverts to the default
	setting. See "Default Setings" on pg 3-15. In addition,
	the line assignments will change on all attendant consoles.
	NOTE: Be sure to record the changes on the appropriate
	planning forms.

With a Display Console

1Enter administration mode by sliding the T/P switch to P .

2 Press Conference twice.

The administration menu appears.

3Press [System], [Size] .

4Press [Small] or [Large] for the system size wanted.

You see the message, "System is Re-starting..." The system

renumbers, then the administration. menu appears on the display.

5Continue administration or leave administration mode by sliding the T/P switch to the center position.

With a BIS-34D Console

1Enter administration mode by sliding the T/P switch to P.

2Press Conference twice.

Lights flash next to Adm Tel, Adm Pool Message and Speaker.

3Press Message.

Light goes on steady next to Message. Flashing lights go off.

4 Dial #201.

Two beeps sound.

5Dial number to designate system size: 0 = small

1 = large

Lights flash next to Adm Tel, Adm Pool, Message and Speaker.

Administering a Changed System 3-65