5 Press the Auto Intercom button until the green light next to the button shows the setting you want:
Studygreen light = attendant position
Flashing green light = potential attendant position
Green Iight off cannot be assigned as an attendant position
6 Press #.
The message "System is
7 Continue administration or leave administration mode by sliding the T/P switch to the center position.
Performing Flexible Numbering
C0NSIDERATIONS ●
●
This feature can be administered only from a MERLIN
IISystem Display Console. It is available with Feature Module 2 and Release 3, not with Feature Module L
Flexible Numbers, except for tie lines, can be one to four digits but the first digit cannot be 0.
If you combine short flexible numbers with long ones, the longer numbers cannot begin with the same digit as the shorter ones. For example, a hotel couldn’t assign the number 2 to the bellhop and the number 201 to room 201 because when callers begin to dial mom 201, they would be connected to the bellhop as soon as they dialed 2.
For Release 3, the following numbers cannot be used for flexible numbering: 7,76,77,78,760 through 783, and 7600 through 7839. These numbers were reserved for CMS split codes used only with FM2.
If your system is using basic telephones, you should not use 9 or 88 as flexible numbers. If the basic telephones are connected through a BTMI,
Administering a New System
